Mocet IG7200 User Manual

 1/53 Copyright © 2012, All Rights Reserved.IG7200 Smart Phone Gateway User Guide

 10/53Off PSTN Line is idle Flashing PSTN receives incoming call, flashing according to the receive cadence 2.2 Rear Panel Figure 4 Rear

 11/533.IG7200Voice GeneralFeatures3.1 Access Control for Web Page The Access Control settings allow the System Administrator to configure th

 12/53 4.Configuration4.1 Setup z Connect the IG7200 LAN port to PC. z The default LAN IP of the IG7200 is 192.168.123.1. z The default WAN

 13/53 4.2 Establish the Connection Enter the IP address of IG7200 from the Web Browser. A Dialogue Box will pop up to request the user to enter

 14/53Figure 6 Information 4.3 Wizard This section allows user to configure the WAN connection type and Wireless Settings. WAN Type Selection:

 15/53 Figure 7 WAN Connection and Wireless settings 4.4 Information This information reflects the current Status of IG7200 connection. It

 16/534.4.2 WAN/LAN Packet Statistics In these two pages, you can get the traffic statistics of the WAN/LAN interface. Click “Reset” to clean up

 17/53 Figure 10 Routing table 4.4.4 ARP This page shows an ARP table which maps network IP addresses to hardware Addresses used by data link

 18/534.4.5 DHCP In this page, you can get the information for each LAN IP lease status. Figure 12 DCHP

 19/534.5 Network setting Network setting allows system administrator to configure the following topics: z WAN z LAN z NTP z UPnP z DDNS z ICE z

 2/53Environment The equipment you have purchased must not be disposed of with household waste. You should return these to your distributor if th

 20/53configuration parameters such as the subnet mask and default router, and to provide other configuration information. This page shows the se

 21/534.5.2. LAN It allows you to set LAN IP and Subnet Mask for LAN interface. You can also enable or disable DHCP Server and configure related

 22/534.5.3. NTP This page allows you to configure the Internet time setting. You can configure the “NTP server”. And the IG7200 can synchronize

 23/534.5.4. UPNP Universal Plug and Play (UPnP) is a set of networking protocols that permits networked devices, such as personal computers, g

 24/53 Operation & Condition 1. When user enable or disable uPNP function, IG7200 will send PMP configuration Request to uPNP Server and g

 25/534.5.5. DDNS The Dynamic DNS service allows you to alias a register domain name to a dynamic IP address. It allows IG7200 to be more easily

 26/53 Figure 19 Internal Softswitch Settings 4.5.7. Mal-reg The Mal-reg setting is used to avoid mal-registration packet attacked from outsi

 27/53 Figure 20 Mal-reg 4.5.8. Advance Advanced Setup allows system administrator to configure the following topics: z Virtual Servers z Rou

 28/53 Figure 21 Virtual Servers Setting 4.5.8.2 Routing The Routing allows you to add special routing rules into routing table. Figure 22 R

 29/53Figure 23 Add Routing Rule 4.5.8.3 IP Filter-Outgoing setup It allows system administrator to create a filter rule to identify outgoing

 3/53their respective owners. WARNING!1. Read these installation instructions carefully before connecting the equipment to its power adapter.

 30/53Figure 25 Add IP Filter-Outgoing 4.5.8.4 IP Filter-Incoming setup It allows the administrator to create a filter rule to identify incomi

 31/53Figure 27 Add IP Filter-Incoming Setup

 32/534.6 System Settings Use the System screen to configure the IG7200’s voice related parameters. It allows system administrator to configure

 33/53Mobile number: The mobile number can show the smart phone’s mobile number, if a smart phone is registered, the mobile number will synchroni

 34/53C.O. Line: FXO caller ID. Analog-> Packet Gain(dB): Adjust the volume of voice, which is transferred from analog signal to VoIP packet.

 35/53needs not change it in common case) DTMF CID: The settings allow administrator to change the DTMF start and end digit, if it needs special

 36/534.6.4 IP Camera IG7200 can connect with IP camera and support remote video monitor function. User can access to IG7200 IP-Cam and do video

 37/534.7 Wireless Use the Wireless screen to configure the IG7200 for wireless access. It is separated into 5 parts: z Basic z Security z Adva

 38/53 Figure 33 Wireless-Security 4.7.3 Advanced This page allows you to configure advanced features of the wireless LAN interface. You can se

 39/53Figure 34 Wireless-Advance 4.7.4 Station Info This page shows wireless stations’ status. Figure 35 Station information 4.7.5 Power

 4/53Table Of Contents 1. Introduction ...

 40/53Figure 36 Power saving setting 

 41/534.8 Advance Settings The system administrator can setup the audio and tone related parameter as following topics: z Audio z Gain &

 42/53 Figure 37 Audio Setting 4.8.2 Gain & Frequency It is used to setup tone-related parameters. Figure 38 Gain & Frequency Setti

 43/534.9 System Management The system administrator can do the following functions to manage the configurations, events, and software update of

 44/53Figure 40 System Management-User Management-modify password 4.9.2 Web Language IG7200 support 3 kinds Languages: English, Simple Chines

 45/534.9.3 Update The new released software could be upgraded from the Local PC side or remotely. Click the “Browse” to locate the new software

 46/53Figure 43 System Management-User Management 

 47/534.9.5 Update Certificate This page allow user to manually update APPLE certificate file and Key File for iOS APNs(Apple Notify Service) Se

 48/53 4.9.7 System Log This page allows engineer for advanced debug for IG7200. Figure 44 System Log 

 49/534.9.8 System Packet Log This page allows engineer to capture the packet from WAN or LAN port. Figure 45 System Packet Log 4.9.9 Reboot

 5/534.7.4 Station Info ... 39 4.7.5 Po

 50/53Figure 47 Event Log Configuration 4.9.11 Reset Select “Factory Default” can be returned to default setting. Figure 48 System Reset 

 51/53Appendix 1: Product Summary TCP/IP Protocols  IP Protocol (791)  ARP (RFC 826) / RARP (RFC 903)  ICMP (RFC792)  TCP (RFC 793)  UDP

 52/53 Real Time Protocol (RTP ; RFC 1889)  MD5 (RFC3261 HTTP) digest authentication  G.168 Echo Cancellation  Voice Codec: G.711u, G.711

 53/53 One 10/100BaseT Ethernet port (RJ-45) for LAN interface  One PSTN Line interface (RJ-11) Power Requirement  Input : Voltage Range 90

 6/53Figure24IPFilter‐OutgoingSetup...29 Figure25Add

 7/531. IntroductionMOCET Smart Phone gateway, IG7200, is an all-wireless solution for home users. With MOCET IG7200 and soft client, user can

 8/53 Figure 2 The full application of IG7200 system Interface  WAN Interface: one 10/100 Base-T Ethernet port  LAN Interface: one 10/

 9/532. GettingtoKnowtheIG72002.1F rontPanel1. The front panel contains several LEDs that indicate the status of the IG7200. Figure 3